Filter
Top Products
GENERATOR OUTPUTS/GAUGE READING
The AC ammeter and AC voltmeter change-over switches
on the control panel DO NOT effect the generator output.
They are provided to help observe how much power is being
supplied, produced at the UVWO terminals lugs.
Before taking a reading from either gauge, set the Voltage
Selector Switch (Figure 14) to the position which produces
the required voltage (For example, for 3Ø 240V, choose
the center 3Ø 240/139V position on the voltage selector
switch.)
Figure 14. Voltage Selector Switch
240/139V 3
Ø Positio
To determine the voltage between two terminal lugs, set
the to the appropriate
setting (Figure 15) to activate the
(Figure 16) and read the available voltage between the
two lugs.
For example, to measure the voltage between the W and U
terminal lugs, set the
to W-U and read the
NOTICE
For 3Ø 208V/1Ø,120V, place the Voltage Selector
Switch in the 3 Phase 240/139 position.
Change-Over Switch
Gauge
Reading Amperage
To determine the amperage at a terminal lug, set the AC
Ammeter Change-Over Switch to the appropriate setting
(Figure 17) to activate the AC Ammeter Gauge (Figure 18)
and read the available amperage at the terminal lug.
For example, to measure the amperage at the U terminal
lug, set the AC Ammeter Change-Over Switch to U and
read the AC Ammeter Gauge.
AC Ammeter
Change-Over Switch
AC Ammeter
NOTICE
The ammeter gauge will only show a reading when
the Output Terminal Lugs are connected to a load
and in use.