Filter
Top Products
10
For edging (when using the line head cutting attachment
with EZ-Link™ models), lock the release button of the
cutting attachment into the 90° edging hole or the 180°
edging hole. See Figure 11.
Operating the EZ-Link™ System
The EZ-Link™ system enables the use of these optional
Add-Ons:
Blower/Vacuum . . . . . . . . . . . . . . . . . . . . . . . . . . BV720r
Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GC720r
Edger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LE720r
Hedge Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . . HS720r
Snow Thrower . . . . . . . . . . . . . . . . . . . . . . . . . . . ST720r
Straight Shaft Trimmer . . . . . . . . . . . . . . . . . . . . SS725r
Tree Pruner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TP720r
Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . TB720r
Removing the Cutting Attachment or Add-Ons
1. Turn the knob counterclockwise to loosen. See Figure 9.
2. Press and hold the release button. See Figure 9.
3. While firmly holding the upper shaft housing, pull
the cutting attachment or add-on straight out of the
EZ-Link™ coupler. See Figure 10.
Installing the Cutting Attachment or Add-On
NOTE: Place the unit on the ground or on a work bench
to make add-on installation or removal easier.
1. Turn knob counterclockwise to loosen.
EZ-Link™ Coupler
Release Button
Guide Recess
Knob
Primary Hole
Upper Shaft Housing
EZ-Link™ Coupler
2. While firmly holding the add-on, push it straight into
the EZ-Link™ coupler. See Figure 10.
NOTE: Aligning the release button with the guide recess
will help installation. See Figure 9.
3. Turn the knob clockwise to tighten. See Figure 11.
Knob
Lower Shaft Housing
Release Button
90˚ Edging Hole
(Trimmer Only)
180˚ Edging Hole
(Trimmer Only)
CAUTION: Lock the release button in the
primary hole and securely tighten the knob
before operating this unit
SECTION 6: OPERATING INSTRUCTIONS
Figure 11
Figure 10
Figure 9
CAUTION:
The cutting attachment and add-
ons with the EZ-Link™ system are to be used
in the primary hole unless stated otherwise in
the specific add-ons operator’s manual.
Using the wrong hole could lead to personal
injury or damage to the unit.
WARNING: Read and understand the
operator’s manual for each add-on prior to
operation.
WARNING: To avoid serious personal injury
and damage to the unit, shut off the unit
before removing or installing add-ons.