Filter
Top Products
13
CLEANING
Switch off the unit and disconnect it from the power
source. Use a small brush to clean off the outside of the
unit. Do not use strong detergents. Household cleaners
that contain aromatic oils such as pine and lemon, and
solvents such as kerosene, can damage plastic housing
or handle. Wipe off any moisture with a soft cloth. Also
keep the air vents free of obstructions.
INSPECT EXTENSION CORDS
Inspect all extension cords. Look closely for deterioration,
cuts or cracks in the insulation. Inspect the connectors for
damage. Replace a damaged or defective cord.
STORAGE
• Allow the unit to cool before storing.
• Lock the unit to prevent unauthorized use or damage.
• Store the unit in a dry, well-ventilated area.
• Store the unit out of the reach of children.
Shaft
Plunger
NOTE: The inner reel must be totally dry before
reinstalling it into the outer spool. Do not
lubricate the inner reel or outer spool assembly.
6. Place the inner reel into the outer spool.
7. Place the bump knob, spring and foam seal into the
inner reel (Fig. 20).
8. Press the bump knob down and tighten clockwise.
9. Install new line as described in Line Installation for
the SpeedSpool
®
.
5. Clean the shaft and the inner surface of the outer
spool. To clean the shaft underneath the plunger,
press down on the plunger (Fig. 24). Remove any dirt
or debris from the shaft.
Fig. 24
Inner Reel
Fig. 23
MAINTENANCE AND REPAIR INSTRUCTIONS
To avoid serious
personal injury,
always turn your unit off and unplug it
before you clean or service it.
WARNING: