Filter
Top Products
3
SECTION 1: TO THE OWNER
Model 625 and Model 626 Twin Rear Bagger Kits are grass collection systems designed for use on Revolution
™
and
ZTT Model Lawn Tractors equipped either a 42-inch cutting deck (Model 625) or a 46-inch cutting deck (Model 626)
only. It will NOT fit on any other tractor, regardless of the tractor’s FastAttach
™
compatibility.
The instructions in this manual are divided into sections. Carefully read all sections and study the illustrations to
ensure proper installation and usage of this attachment. Read and observe all WARNING statements. They are
included to provide for the protection of the equipment installer and user, and to ensure the prolonged service life of
the equipment.
NOTE: References to LEFT and RIGHT indicate the left and right sides of the tractor when facing forward in the
operator’s position. Reference to the FRONT indicates the grille end; to the REAR the drawbar end.
SECTION 2: CONTENTS OF CARTON
Before beginning installation, remove all parts from the carton to make sure everything is present. Carton contents
are listed below and shown in . Hardware part number are shown in parentheses.
One Chute Tube
One Discharge Tube Assembly
One Set of Blades (Model 626 only)
One Extension Tube
Two Grass Bag Assemblies
One Grass Catcher Cover Assembly
One Bracket Assembly w/ Clevis Pin (711-0309A)
& Hairpin Clip (714-0117) in place.
Figure 2
Chute Tube
Discharge Chute
Assembly
Bag Assemblies
Cover Assembly
Bracket Assembly
Support Tube
(attached to cover)
Blades
(Model 626 Only)
Extension
Tube