Filter
Top Products
6
SECTION 5: ASSEMBLY INSTRUCTIONS
IMPORTANT:
After assembly, service engine with
gasoline, and check oil level as instructed in the
separate engine manual packed with your unit.
NOTE:
All references to right or left side of the
snow thrower are determined from behind the unit in
the operating position.
UNPACKING
• Remove staples or break glue on the top flaps
of the carton. Remove any loose parts
included with unit (i.e., Operator’s Manual, etc).
• Cut along dotted lines and lay end of carton
down flat. Remove packing material.
• Roll unit out of carton. Check carton
thoroughly for loose parts before discarding.
TOOLS REQUIRED FOR ASSEMBLY
• (1) 3/8" Wrench
• (2) 7/16" Wrench*
• (2) 1/2" Wrench*
• 9/16” Wrench
• Pair of pliers
*or adjustable wrench
LOOSE PARTS IN CARTON See Figure 3
Figure 3
A (2) Handles (Right and Left)
B (1) Handle Panel Assembly
C (1) Chute Assembly
D (1) Chute Crank Assembly w/ Upper
Mounting Bracket
E (1) Shift Rod
(1) Hardware Pack (not illustrated)
A
B
C
D
E