Filter
Top Products
8 Section 3 — ASSembly & Set-Up
Bag
1. Grasp bag handle with one hand and slide locking rod on
mounting bracket with other hand toward engine. Use
the end of mounting bracket as leverage when sliding the
locking rod. See Figure 3-4.
4
3
1
2
Figure 3-4
2. Slip bag over the rim of the discharge opening and release
locking rod to secure bag in place.
3. Snap bag clip to the top of the lower handle.
4. Place the lower straps on the bag over the top of lower
handle, hooking them on the studs. See Figure 3-4.
NOTE: The bag/chute switch button attached to the
mounting bracket must be fully depressed by the tip of
front tab on bag handle when securing the bag or engine
will not start.
4. Loosen the wing nut that secures the rope guide to the
right side of upper handle.
a. Slowly pull starter rope out of engine.
b. Slip the starter rope into the rope guide.
c. Tighten the wing nut. See Figure 3-3.
A
B
C
Figure 3-3