Filter
Top Products
8
Also, be certain the smaller front wheels and the larger
rear wheels are mounted correctly to the front and rear
of the mower as shown in Figure 1.
Figure 1
Assembling Handle
Installing the Lower Handles (Hardware A)
• Insert long end of the lower handle into the handle
base. Make certain the small hole in the end of the
handle is lined up with the hole in handle base.
• Using one of the two longer self tapping screws
from the hardware pack, insert the screw through
the tooth washer, flat washer, and the handle cap
as shown in Figure 2.
• Align the handle cap so it rests flush against the
handle base, and tighten the screw into the lower
handle using a phillips screwdriver.
• Repeat this step for the remaining lower handle.
• Once both lower handles are installed, insert the
lower handle plugs into the upper ends of the lower
handles as shown in Figure 2.
Figure 2
Installing the Upper Handle (Hardware B)
• Standing behind the lawnmower with the upper
handle, make certain the two holes that will hold the
blade / motor control are on the right hand side.
See Figure 3 for proper alignment of upper handle.
Figure 3
• Align the holes in the lower handle with those of the
upper handle and insert the hex and handle bolts
through both holes as shown in Figure 3 .
Right Front View
Cutting Height Positions
Low
Medium
High
Front Wheel
Rear Wheel
Hubcap Assembly
Hubcap Assembly
Flat Washer
Tooth
Self Tapping
Handle Cap
Handle Base
Screw
Lower Handle
Lower Handle
Plug
Washer