Filter
Top Products
13
5
Making
Adjustments
WARNING
Loose gravel can be picked
up and thrown by the
auger, causing injury to the
operator and bystanders
and/or damage to the snow
thrower and surrounding
property.
Skid Shoes
The space between the skid shoes and the ground can
be adjusted.
• For close snow removal on a smooth surface, raise
skid shoes higher on the auger housing.
• Use a middle or lower position when the area to be
cleared is uneven, such as a gravel driveway.
To adjust the skid shoes:
1. Loosen the four hex nuts (two on each side) and
carriage bolts. Move skid shoes to desired position.
2. Make certain the entire bottom surface of skid shoe is
against the ground to avoid uneven wear on the skid
shoes.
3. Retighten nuts and bolts securely.
NOTE: Some models are equipped with reversible skid
shoes and may be turned over to increase their lifespan.
See Figure 5-7 and 5-8.
Chute Bracket Adjustment
If the spiral at the bottom of the chute directional control
is not fully engaging with the chute assembly, the chute
bracket can be adjusted. To do so:
1. Loosen the two nuts which secure the chute bracket
and reposition it slightly. See Figure 5-9.
2. Retightening the nuts.
Tire Pressure
Before operating, check tire pressure and reduce pres-
sure to between 15 psi and 20 psi.
If the tire pressure is not equal in both tires, the unit may
not travel in a straight path and the shave plate may wear
unevenly.
Figure 5-6 - Standard Skid Shoe
Figure 5-9
Figure 5-7 - Steel Reversible
Figure 5-8 - Plastic Reversible