MTD 753-05193 Log Splitter User Manual


  Open as PDF
of 2
 
9. Using two 3/4” wrenches, remove and discard the
bolt and nut securing the cylinder ram to the wedge.
10. Slide the wedge away from the cylinder ram enough
to slip the Shim Assembly, Item 1, between the wedge
and cylinder ram. See Figure 3.
11. Re-align the hole in the cylinder ram end and the
holes in the wedge ears.
12. Slip the new 1/2”-13 x 3.25 Screw, Item 2, through
the wedge, cylinder ram and shim assembly holes.
13. Secure with the new 1/2”-13 Lock Nut, Item 3.
DO NOT tighten the lock nut down. There should be
only 2 to 3 threads that show past the nut.
See Figure 4.
14. This completes the installation of this service kit.
SHIM
(ITEM 1)
FIGURE 3
CYLINDER RAM
WEDGE EARS
ASSEMBLY
Service Kit 753-05193 Pg 2 of 2 Form No. 769-02077
NOTES
 previous