Filter
Top Products
9
Auger Control
The auger control is located on the left handle.
Squeeze the auger control against the handle to
engage the augers and start snow throwing action.
Release to stop.
Drive Control
The drive control is located on the
right handle. Squeeze the drive
control against the handle to
engage the wheel drive. Release
to stop.
4 Way Chute Control
(optional)
This four-way control lever is meant to control the
direction and distance of snow discharge from the
chute. Press the button on the knob and pivot it left or
right to rotate the chute to the direction that snow will be
thrown. Tilt the lever forward or rearward to adjust the
distance snow will be thrown.
2 Way Chute Control (optional)
This two-way control lever is meant to control the
distance of snow discharge from the chute. Tilt the lever
forward or rearward to adjust the distance snow will be
thrown.
Chute Directional Control (optional)
The chute directional control is located on left side of
the snow thrower.
To change the direction in which snow is thrown, turn
chute directional control as follows:
• Crank clockwise to discharge to the left.
• Crank counterclockwise to discharge to the right.
Clean-Out Tool
WARNING: Never use your hands to clear
a clogged chute assembly. Shut off engine
and remain behind handles until all moving
The tool is designed to clear a clogged chute assembly.
Refer to Operating Your Snow Thrower section for more
detailed information regarding the chute clean-out tool.
Skid Shoes
The space between the shave plate and the ground can
be adjusted by moving the skid shoes.
For close snow removal and hard packed snow, place
skid shoes in the lowest position. Use middle or high
position when area to be cleared is uneven or gravel
surface.
Make certain the entire bottom surface of the skid shoe
is against the ground to avoid uneven wear on the slide
shoes.
Recoil Starter Handle
The recoil starter handle is used to manually start the
engine.
Electric Starter Button (If so equipped)
Pressing the electric starter button engages the
engine’s electric starter when plugged into a 120V
power source.
Chute
Control Lever
CHUTE DIRECTIONAL CONTROL
COMMANDE D'ORIENTATION DE LA GOULOTTE