Filter
Top Products
7
SECTION 4: UNPACKING
TO REMOVE UNIT FROM CARTON
1. Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to open
carton.
2. Remove loose parts if included with unit (i.e.,
owner’s manual, etc.).
3. Cut along dotted lines and lay carton down flat.
4. Remove packing material.
5. Roll or slide unit out of carton. Check carton
thoroughly for loose parts.
NOTE:
Parts included for assembly of grass catcher
are listed on page 8.
TOOLS REQUIRED FOR ASSEMBLY
Pair of Pliers
Phillips Screwdriver †
7/16" or Adjustable Wrench †
† Hardtop Grass Bags Only.
DISCONNECT SPARK PLUG WIRE
Before setting up your lawn mower, disconnect the
spark plug wire from the spark plug, and ground it
against the engine. See Figure 3.
NOTE:
On engines with a rubber boot, attach rubber
boot to a bolt on the engine to ground.
Figure 3
Figure 4
All Engines Tecumseh
Boot
With Rubber
Briggs & Stratton
Engines
Engines
Spark Plug Wire
With Rubber Boot
Spark
Plug
Wire
V-Slot
on Engine
Spark
Plug
Retaining
Post
Spark Plug Wire
Spark Plug
Wing Nut
Rope
Guide
Starter
Rope
Upper
Handle
Blade Control Handle
Hand Knob
Spark
Plug
Rope
Guide
Lower
Handle
Rear
Discharge
Door
Handle
Mounting
Bracket
Lower
Handle
Hair Pin
Clip In
Inner Hole
Handle
Mounting
Bracket
Weld Pin
Hair Pin
Clip In
Inner Hole