Filter
Top Products
11
WARNING:
Shift lever only with the engine running. Shifting with the Drive Clutch Control
engaged can damage the transmission.
CUTTING HEIGHT ADJUSTMENT LEVERS
The cutting height adjustment levers are located above each wheel. Cutting heights are from 3/4” to 4-1/2"
with 3/8" increments. The low range setting is 3/4" to 2-5/8” and the high range setting is from 2-5/8” to 4-1/2”.
To adjust the cutting height, push the levers away from the mower and then move it forward or back for a new
cutting height. Repeat for each wheel. See Figure 3. Make sure each wheel is in the same height position.
Figure 3
There are two positions on the height adjusters to mount the wheels. One for the low range and one for the
high range. The wheels are installed in the holes for the higher cutting range at the factory. See Figure 3.
NOTE:
For types of grass that require extremely low or high adjustment, move the height adjustment lever
to a higher position. This will help to prevent you from scalping.
ENGINE CONTROLS
See the engine manual for the location and function of the controls located on the engine.
SECTION 5: OPERATION
WARNING:
Keep hands and feet away from the chute area on cutting deck. See Figure 1. The
operation of any lawn mower can result in foreign objects being thrown into the eyes, which can
result in severe eye damage. Always wear safety glasses or eye shields.
NOTE:
For best results raise the cutting position until it is determined which height is best for your lawn. See
CUTTING HEIGHT ADJUSTMENT LEVER in the CONTROLS section.
GAS AND OIL FILL-UP
Service the engine with gasoline and oil as instructed in the separate engine manual. Read all instructions
carefully. Use SAE 10W30, API Service class SE or higher, 19 oz (0.6 qts). See Engine Manual
WARNING:
Never fill fuel tank indoors, with engine running or until the engine has been allowed
to cool for at least two minutes after running.
Dual Range Adjustment
Low Range
High Range
Adjustment Lever