Filter
Top Products
12 se c t i O n 4 — as s e M b l y & in s t a l l a t i O n
Assembling Remaining Bagger Components
Now that the mounting brackets are assembled and are in place
on the tractor, follow these steps to assemble the remaining
bagger components.
Snap the plastic upper chute support in place by first 1.
clipping the side portion onto the bagger support rail with
the edge of the snap feature aligned with the red line, as
seen in Fig. 4-11.
Snap the front side of the chute support to the rail, as 2.
shown in the inset of Fig. 4-11.
Install the bagger hanger assembly onto the mounting 3.
assembly on the tractor by hooking it over the hitch plate
between the two tabs. See Fig. 4-9.
Secure the hanger assembly to the mounting assembly 4.
using a 5/16” bolt and flange nut provided. See Fig. 4-10.
Tabs
Top View
1
2
Figure 4-9
Figure 4-10
Figure 4-11