MTD 190-032-101 Snow Blower User Manual


 
14
Maintenance
WARNING: Before lubricating, repair-
ing, or inspecting, place tractor on a
firm and level surface. Place the PTO
in the disengaged (OFF) position, set
the parking brake, shut engine off, and remove key
to prevent unintended starting.
Lubrication of
Chute Directional Control
The spiral on the end of the lower chute crank, the base
of the discharge chute itself and the joint blocks which
connect the lower and upper chute cranks should be
lubed with multi-purpose automotive grease once a
season. See Figure 12–1.
Auger Shaft
1. At least once a season, remove the shear bolts on
the auger shaft. Oil or spray lubricant inside and
on the plastic bearings on the shaft and near the
holes where the shear bolts were removed before
reattaching them. See Figure 12–2.
Figure 12–2
Figure 12–1
Lube Spiral
and Chute Base
Joint Block
Shear Pin
Bearing
Spacers
12
Maintenance
Before lubricating,
repairing, or
inspecting, place
tractor on a firm
and level surface.
Place the PTO in
the disengaged
(OFF) position, set
the parking brake,
shut engine off, and
remove key to prevent
unintended starting.
WARNING