Meyer 62517 Spreader User Manual


 
8
INSTALLATION INSTRUCTION FOR
ELECTRIC THROTTLE CONTROLS
(FACTORY INSTALLED ACTUATORS)
BEFORE BEGINING ANY INSTALLATION ON THIS UNIT, disconnect the spreader battery
negative cable if already installed.
PREPARING UNIT:
1. Spreaders with factory installed throttle controls do not require installer hook-up to the engine. The
actuator has been installed and tested at the factory.
2. Raise the engine shroud and securely prop it in place with the prop rod. The installer will have to remove
the ties securing the coiled actuator cable to the top of the engine.
3. The throttle actuator cable plugs into the in-cab control panel after being routed from the cab of the
vehicle to the rear of the mounted spreader.
4. Select a suitable location in the cab of the vehicle to mount the throttle control box.
Consult vehicle manufacturer for acceptable mounting locations. Improperly mounting the control box could
interfere with air bag(s) and the other functions of the occupant protection systems, such as knee bolsters!
5. After the location of the control panel is determined, the cable must be routed to the front of the spreader,
Route cable under the cab and up to the front of the spreader securing as needed. Allow enough cable for
the control panel to be mounted in the cab.
6. The routed cable must be clear of all moving or hot parts on the sreader or vehicle. Secure the cable with
the ties provided. Excess cable must be coiled up and secured. Apply dielectric grease on Item # 21
page 46 for protection from salt spreading envoirment.
7. Mount the control panel (with screws supplied).
8. For permanent cable mount at rear of the truck, a mounting bracket is supplied.
9. Install a 12 volt battery with 40 ampere hour rating, recommended for winter use (if not already done). The
battery hold-downs furnished will accept any 2 SM Series battery.
WARNING
WARNING