Melissa 670-208 Patio Heater User Manual


  Open as PDF
of 22
 
10
11
• Mount heating head on curved bar so that hole in bar is aligned with hole in
heating head. Secure using mounting screw.
• Checkthattheapplianceisrmlyxedinplacebeforeusingit.
Models with stand (model 670-207/209/211)
• The appliance should be sited at least 1m from the
nearest wall. The heater head should be at least 30cm
fromtheceiling,andatleast1.8mabovetheoor.The
applianceshouldstandrmlyonahorizontaloor.
• Fit lower part of stand (b) in base (a), lay base on
its side, and fasten stand to underside of base with
washer and screw (c) (See illus. I).
• Position base correctly so that stand is upright. Slacken
screw (c) in middle of stand (d), and insert middle part
into lower part. Align screw with recess in lower part
(seeillus.II).Tightenscrew.Inthesameway,xupper
part of stand (e) in middle part with a screw (see illus.
III).
• Extend thin rod (f) from sleeve (g) at top of rod to
desired height. Fit cuff (h) over thin rod. Tighten cuff
(see illus. IV).
• Mount heating head on thin rod so that hole
in the rod is aligned with hole in heating
head. Secure using mounting screw (14) (see
illus. V). Tighten all screws thoroughly.
• Checkthattheapplianceisstandingrmly
in place before using it.
• The cable may be secured in the cable
holder (j) on the stand.
• The curved stand can be rotated 360°
so that the heating head can face in any
direction.
OPERATING THE APPLIANCE
• If the appliance has a stand, angle and
height of heating head can be adjusted.
o Set head at desired angle by turning the hinge (12).
o Set head at required height by slackening the cuff and extending or retracting
the thin rod.
• The appliance is not thermostatically controlled and continues to emit heat until
it is switched off. Always keep an eye on the appliance while it is switched on.
• Remove the plug from the wall socket when appliance is not in use.
Models with no remote control:
• Plug in and switch on the power.
• The appliance is switched on, setting selected and switched off by pulling the
string (5). Settings can be seen in function indicator (4): The appliance will switch
to next setting each time the string is pulled (see list below).
• Switchapplianceoffwhenyouhavenishedusingit.Pullstringrepeatedlyuntil
indicator shows "0".
Models with remote control:
• Pluginandswitchonthepower.Thegreendiodewillashtoindicatethe
appliance is on standby.
• Press On/Power (8) once on the appliance or remote control to switch on at
lowest setting. Switch between low, medium and high using this button. Settings
can be seen in the function indicator (7) (see list below).
• Press Off (10) on appliance or remote control to return to standby. Caution!
The appliance will not be completely switched off using the Off button, but will
gointostandbymode(greendiodewillash).Disconnectpowerandcheckall
diodesareoutwhennishedwiththeappliance.
• Always point remote control at receiver (9) on heating head when using.
Quartz tubes
The quartz tubes in the appliance (3) emit long wave infrared radiation. They have
a service life of approx. 5,000 hours and must be replaced by an electrician when
burnt out. Quartz tubes are fragile, and must not be touched directly and protected
from impact or shock.
Twodarkspotscanappearonthetubeswithintherstfewminutesofuse.Thisis
normal, and they will disappear after a little while.
CLEANING
• Always switch off at wall socket and unplug before cleaning the appliance.
• Clean the outside of the appliance by wiping with a damp cloth. A little detergent
can be added if the appliance is heavily soiled.
• Never use a scouring pad, steel wool or any form of strong solvents or abrasive
cleaning agents to clean the appliance, as those may damage the outside
surfaces of the appliance.
• Afterextendedperiodsofusedustcancollectonthereectorandtubesbehind
the grille (2). Contact a professional for removing the grille and cleaning the head
inside.
INFORMATION ON DISPOSAL AND RECYCLING OF THIS PRODUCT
Please note that this Adexi product is marked with this symbol:
This means that this product must not be disposed of together with ordinary
household waste, as electrical and electronic waste must be disposed of separately.
In accordance with the WEEE directive, every member state must ensure correct
collection, recovery, handling and recycling of electrical and electronic waste.
Private households in the EU can take used equipment to special recycling stations
free of charge. In certain member states, used appliance can be returned to the
dealer where they were bought on the condition you buy new products. Contact
your retailer, distributor or the municipal authorities for further information on what
you should do with electrical and electronic waste.
GUARANTEE TERMS
The guarantee does not apply:
• if the above instructions are not followed
• if the appliance has been interfered with
• if the appliance has been mishandled, subjected to rough treatment, or has
suffered any other form of damage
• if faults have arisen because of faults in your electricity supply.
Due to the constant development of our products in terms of function and design,
we reserve the right to make changes to the product without prior warning.
QUESTIONS AND ANSWERS
Ifyouhaveanyquestionsregardinguseoftheapplianceandcannotndtheanswer
in this user guide, please try our website at www.adexi.eu.
Gotothe"ConsumerService"menu,clickon"Question&Answer"toseethemost
frequently asked questions.
You can also see contact details if you need to contact us for technical issues,
repairs, accessories and spare parts.
IMPORTER
Adexi Group
www.adexi.eu
We cannot be held responsible for any printing errors.
0 GreendiodeashingOff/standby 0W
L Green diode lit Low power 650 W
M Yellow diode lit Medium power 1,350 W
H Red diode lit High power 2,000 W
Indicator (no
remote control)
Indicator (with
remote control)
Meaning
Power
 previous next