Filter
Top Products
New
Moon
Waning
Crescent
First
Quarter
Waxing
Gibbous
Full
Moon
Waning
Gibbous
Last
Quarter
Waning
Crescent
CHANGING PRESSURE AND ALTITUDE UNITS
• Press MODE as needed, until “LOCAL” pressure is displayed.
• Press and hold HISTORY, until the pressure unit is flashing.
• Change local or sea level pressure units by pressing the UP (? ) or DOWN (? ) buttons to
select the pressure units. Choose from: inHg, hPa/mBar or mmHg.
• Press HISTORY to confirm your selection.
• Press MODE button until the local altitude value will be displayed.
• Press and hold HISTORY until the altitude unit is flashing.
• Select the ALTITUDE unit:, meters or feet, by pressing UP (? ) or DOWN (? ) buttons.
• Press HISTORY to confirm your selection.
VIEWING SEA LEVEL PRESSURE HISTORY
• In pressure mode, press HISTORY button entering the sea level pressure display.
• When the SEA LEVEL is displayed, press HISTORY repeatedly viewing the sea level
pressure history for the past 24 hours in 1 hour intervals.
• If no buttons are pressed for 5 seconds, the unit will automatically return to the default
Pressure and Weather Forecast Mode.
VIEWING PRESSURE, TEMPERATURE AND HUMIDITY CHARTS
The bar chart in Pressure Window can be configured to display a historical data for the sea
level pressure and temperature or humidity for channel 1.
After selecting the Pressure Window, press and hold ALARM button to toggle the bar chart
between the sea level pressure with a word “PRESSURE” displayed at the right bottom corner
of the chart, temperature with a thermometer icon and “CH1” and a humidity with “RH” icon
and “CH1”.
MOON PHASE ICONS
TEMPERATURE/ HUMIDITY WINDOW
The main unit supports up to 3 remote sensors, corresponding to a separate channel of the
temperature and relative humidity display. The temperature can be displayed in Celsius (ºC)
or Fahrenheit (ºF).
The main unit carries the temperature and humidity sensor and uses this data to calculate an
indoors comfort level - Wet, Comfort or Dry.
A temperature alert function is available for all channels. It can be programmed to sound if the
channel temperature exceeds or falls below the pre-set upper and lower limits.
10