Filter
Top Products
OBSERVING
Observe during the daytime: Try out
your telescope during the daytime at
first. It is easier to learn how it
operates and how to observe when it
is light.
Pick out an easy object to observe: A
distant mountain, a large tree, a lighthouse
or skyscraper make excellent targets. Point
the optical tube so it lines up with your
object.
Unlock the lock knobs: To move the
telescope, you will need to unlock the
horizontal (6) and vertical (5) lock knobs (just
rotate to unlock or lock; when locking, only
tighten to a “firm feel,” do not overtighten).
Use the viewfinder: If you have not done so,
align the viewfinder (2) with the telescope’s
eyepiece (1) as described earlier.
Look through the viewfinder until you can
see the object. It will be easier to locate an
object using the viewfinder rather than
locating with the eyepiece. Line up the object
in the viewfinder’s crosshairs.
Look through the eyepiece: Once you have
the object lined up in the viewfinder, look
through the optical tube’s eyepiece. If you
have aligned your viewfinder, you will you
see the object in your eyepiece.
Focus: Look through the eyepiece and
practice focusing on the object you have
chosen.
Try out the coarse and fine adjustment
controls: Practice using the fine adjustment
control (16) to move the telescope. These
can come in very handy, especially when you
wish to move the telescope in very small
(fine control) steps.
6
TOO MUCH POWER?
Can you ever have too much power? If the type of
power you’re referring to is eyepiece magnification,
yes you can! The most common mistake of the
beginning observer is to “overpower” a telescope
by using high magnifications which the telescope’s
aperture and atmospheric conditions cannot
reasonably support. Keep in mind that a smaller,
but bright and well-resolved image is far superior
to one that is larger, but dim and poorly resolved.
Powers above 400x should be employed only under
the steadiest atmospheric conditions.
Observe the Moon: When you feel
comfortable with the viewfinder, the
eyepieces, the locks and the adjustment
controls, you will be ready to try out the
telescope at night. The Moon is the best
object to observe the first time you go out at
night. Pick a night when the Moon is a
crescent. No shadows are seen during a full
Moon, making it appear flat and
uninteresting.
Look for different features on the Moon. The
most obvious features are craters. In fact
you can see craters within craters. Some
craters have bright lines about them. These
are called rays and are the result of material
thrown out of the crater when it was struck
by a colliding object. The dark areas on the
Moon are called maria and are composed of
lava from the period when the Moon still had
volcanic activity. You can also see mountain
ranges and fault lines on the Moon.
Use a neutral density filter (often called a
“moon filter”) when observing the Moon.
Neutral density filters are available from
Meade as an optional accessory and
enhance contrast to improve your
observation of lunar features.
40-04135 8 Page Manual Template 6/29/05 10:54 AM Page 8