McCulloch ZM3016BF/966564001 Lawn Mower User Manual


  Open as PDF
of 56
 

27
Slowly push the choke control down when the engine
has started.
Set the desired engine speed with the throttle. Allow
the engine to run at a moderate speed, “half throttle”
for 3-5 minutes before loading it to heavily. USEFULL
THROTTLEWHENMOWING (no choke).
WARNING!
Engineexhaustandcertainvehicle
componentscontainoremitchemicals
consideredtocausecancer,birth
defects,orotherreproductivesystem
damage.Theengineexhaustcontains
carbonmonoxide,whichisaodorless,
colorless,poisonousgas.Donotuse
themachineinenclosedspaces.
8058-122
Use full throttle when mowing
8011-642
Jumper cable connection
IMPORTANTINFORMATION
Yourmowerisequippedwitha12-volt
negativegroundedsystem.Theothervehicle
mustalsobea12-voltnegativegrounded
system.Donotuseyourmowertostartother
vehicles.
If your battery is too weak to start the engine, it should
be recharged. (See Battery in the Maintenance
section.)
If jumper cables are used for emergency starting,
follow this procedure:
Jumpercables
Connect each end of the RED cable to the 1.
POSITIVE (+) terminal on each battery, taking
care not to short against chassis.
Connect one end of the BLACK cable to the 2.
NEGATIVE (-) terminal of the fully charged battery.
Connect the other end of the BLACK cable to a 3.
good CHASSIS GROUND on the mower with the
discharged battery, away from the fuel tank and
battery.
Toremovecables,reverseorder
Remove BLACK cable rst from chassis and then 1.
from the fully charged battery.
Remove RED cable last from both batteries.2.
WARNING!
Lead-acidbatteriesgenerate
explosivegases.Keepsparks,
ameandsmokingmaterialsaway
frombatteries.Alwaysweareye
protectionwhenaroundbatteries.
 previous next