Filter
Top Products
3-2. CONVERSION TO BLOWER
1. To convert this unit from a vacuum back into a
blower, remove vacuum tubes and push sliding
intake cover to the closed position. (Fig. 3-2A & Fig.
3-2B)
2. Press down the red button (A) on the unit and
remove vacuum bag. (Fig. 3-2C)
3. Pull the blower tube (B) from (C), till it’s engaged.
(Fig. 3-2D)
4.
Attach the blower tubes to the unit by sliding the
large end of the blower tube into the blower outlet
until firmly in place. (Fig. 3-2E)
6 7
3 - ASSEMBLY INSTRUCTIONS
3-2C
Remove blower from carton and examine it thoroughly to
make sure it is not damaged.
This electric blower requires
no tools for assembly. Read your User manual carefully
before assembly and operation.
3-1. VACUUM ATTACHMENT ASSEMBLY
Make sure the unit is unplug from electric outlet.
1. Pull the vacuum/blower slide (A) to top. (Fig. 3-1A)
2. Insert the vacuum tube I (B) into unit (C). Align tabs
(D) on vacuum tube I (B) with grooves (E) in the hous-
ing (Fig 3-1B), and twist in clockwise direction to
ensure the arrow mark (F) is on the assistant handle
side (G). (Fig. 3-1C)
3. Align grooves (K) on vacuum tube II (L) with locking
hole (M) in vacuum tube I (N) (Fig. 3-1D) then connect
2 tubes, unit the two arrows aligned in line. (Fig. 3-1E)
NOTE : The vacuum nozzle should be assembled pointing
up. (Fig. 3-1F)
4. Attach the vacuum bag to the vacuum bag adapter.
(Fig. 3-1G)
5. Insert the bag adapter into the unit. (Fig. 3-1H)
3-1C
F
3 - ASSEMBLY INSTRUCTIONS
3-2B
3-2D
G
3-1D
K
M
N
L
3-1E
3-1F
3-1A
A
3-1B
D
E
C
B
3-1G
3-1H
3-2A
3-2E
A
C
B