Filter
Top Products
-- 4 --
WHAT IS WHAT?
1. Throttle trigger 9. Upper blower tube
2. STOP switch 10. Lower blower tube
3. Primer button 11. High--speed nozzle
4. Choke lever 12. Elbow tube
5. Fuel cap 13. Vacuum bag
6. Starter rope 14. Upper vacuum tube
7. Vacuum handle 15. Lower vacuum tube
8. Spark plug 16. Instruction manual
WHA T IS WHAT?
14
15
13
12
6
1
2
8
9
10
11
4
3
7
5
16
ASSEMBLY
CARTON CONTENTS
Check carton contents aga inst t he fol lowinglist.
S Blower
S Upper blower tube
S Lower blower tube
S High velocity nozzle
S Elbow t ube
S Vacuum bag
S Upper vacuum tube
S Lower vacuum tube
S Screw for vacuum tube assembly
NOTE: It is normal for the f uel filter to rattle
in the empty fuel tank.
ASSEMBLY
WARNING: Stop engine andbe sure
the impeller blades have stopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or remove the v acuum or
blower tubes. The rotating blades can cause
serious injury . Always disconnect the spark
plug before performing maintenance or ac-
cessing movable parts.
WARNING: If received assembled,
repeatall stepstoensure yourunit isproperly
assembled andall fasteners are secure. Fol-
lowallsafety informationinthemanualandon
the unit.
D A standard screwdriver is required for as-
sembly.
BLOWER ASSEMBLY
BLOWER TUBE ASSEMBLY
1. Alignthe rib onthe upper blower tube with
the groove in the blow er outlet; slide the
tube into place.
NOTE: The tube clamp bolt must be loose
enough to allow b lower tube to be inserted in
blower outlet. Loosen the bolt by turning coun-
te rcl o ckwise.
Blower Outlet
Rib
Groove
2. Secure the tube by turning the bolt clock-
wise.
3. Align the slots on the lower blower t ube
with th e tabs on the upper blower tube.