Filter
Top Products
11
1 532 17 05-51 Control Throt. /Ch. Flag
2 817 72 04-08 Screw Hex Thd. Cut 1/4-20 x 1/2
3 - - - - - - - - Engine Briggs 21B807-1393-B1
4 532 17 97-58 Muffler
8 532 17 18-77 Bolt 5/16-18 x 3/4
13 532 16 52-91 Gasket
23 532 16 98-37 Shield Browning/Debris Guard
25 532 19 06-95 Control Choke
29 532 13 71-80 Arrester Spark
31 532 40 75-16 Tank Fuel
32 532 43 02-20 Cap Asm. Fuel
33 532 12 34-87 Clamp Hose Blk.
37 532 13 70-40 Line Fuel 20"
40 532 12 40-28 Bushing
44 817 67 04-12 Screw Hex Wsh. Thdrol. 1/4-20 x 3/4
45 817 00 06-12 Screw Hex Wsh. Thdrol. 3/8-16 x 3/4
46 819 09 14-16 Washer 9/32 x 7/8 x 16 Ga.
72 532 19 23-34 Screw Socket HD 5/16-18 x .75
78 817 06 06-20 Screw 3/8-16 x 1-1/4
81 873 51 04-00 Nut Keps 1/4-20 unc
119 532 19 97-68 Guard Engine LH
120 532 19 97-67 Guard Engine RH
121 532 19 66-88 Clips Threaded
122 532 42 19-22 Extension Drain Oil
123 817 67 05-08 Screw Thdrol. 5/16-18 x 1/2
136 532 13 77-29 Screw Thdrol. 1/4-20 x 5/8
KEY PART
NO. NO. DESCRIPTION
TRACTOR - - MODEL NO. M13597RB (96061028801) PRODUCT NO. 960 61 02-88
ENGINE
Engine Power Rating Information
The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of Automotive En-
gineers) code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance has been obtained and
corrected in accordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower values
are derived at 3600 RPM. Actual gross engine power will be lower and is affected by, among other things, ambient operat-
ing conditions and engine-to-engine variability. Given both the wide array of products on which engines are placed and
the variety of environmental issues applicable to operating the equipment, the gas engine will not develop the rated gross
power when used in a given piece of power equipment (actual “on-site” or net power). This difference is due to a variety
of factors including, but not limited to, accessories (air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.),
application limitations, ambient operating conditions (temperature, humidity, altitude), and engine-to-engine variability.
Due to manufacturing and capacity limitations, Briggs & Stratton may substitute an engine of higher rated power for this
Series engine.
NOTE: All component dimensions given in U.S. inches
1 inch = 25.4 mm