McCulloch ET700 Trimmer User Manual


 
1. Warning.
2. Read the user instructions carefully to make
sure you understand all the controls and what
they do.
3. Switch off! Remove plug from mains before
adjusting, cleaning or if cable is entangled or
damaged. Keep the cable away from the
cutting parts.
4. Do not operate in the rain or leave the product
outdoors while it is raining.
5. The use of eye protection is recommended to
protect against objects thrown by the cutting
parts.
6. Keep others, including children, pets and
bystanders outside the 10 metre hazard zone.
Stop the trimmer immediately if you are
approached.
WARNING: The cutting line continues to rotate
after the machine has been switched off
(Trimmers).
Explanation of Symbols on your Product (Check which symbols apply)
SAFETY PRECAUTIONS
1. Never allow children or people unfamiliar with
these instructions use the product. Local
regulations may restrict the age of the
operator.
2. Only use the product in the manner and for
the functions described in the instructions.
3. Never operate the product when you are tired,
ill or under the influence of alcohol, drugs or
medicine.
4. The operator or user is responsible for
accidents or hazards occurring to other people
or their property.
5. Keep bystanders away. Do not operate whilst
people, especially children or pets are in the
area.
General
Electrical Safety
1. The use of a Residual Current Device
(R.C.D.) with a tripping current of not more
than 30mA is recommended. Even with a
R.C.D. installed 100% safety cannot be
guaranteed and safe working practice must
be followed at all times. Check your R.C.D.
every time you use it.
2. Before use, examine cable for damage. If
there are signs of damage or ageging, it must
be replaced by the manufacturers service
agent or a similar qualified person to avoid
hazard.
3. Do not use the product if the electric cables
are damaged or worn.
4. Immediately disconnect from the mains
electricity supply if the cable is cut, or the
insulation is damaged. Do not touch the
electric cable until the electrical supply has
been disconnected. Do not repair a cut or
damaged cable. Replace it with a new one.
5. Your cable must be uncoiled or unwound,
coiled or wound cables can overheat and
reduce the efficiency of your product.
6. Keep the cable clear of the cutting area and
obstacles at all times.
7. Do not pull cable around sharp objects.
8. Always switch off at the mains before
disconnecting any plug, cable connector or
extension cable.
9. Switch off, remove plug from mains and
examine electric supply cable for damage or
ageing befor
e winding cable for storage. Do
not repair a damaged cable, replace it with a
new one. Use only Electrolux Outdoor
Products replacement cable.
10. Always wind cable carefully, avoiding kinking.
11. Never carry the product by the cable.
12. Never pull on the cable to disconnect any of
the plugs.
13. Use only on AC mains supply voltage shown
on the product rating label.
14. Our products are double insulated to
EN60335. Under no circumstance should an
earth be connected to any part of the product.
Cables
Use only 1.00mm
2
size cable up to 40 metres
length maximum.
Maximum rating:
1.00mm
2
size cable 10 amps 250 volts AC
1. Mains cables and extensions are available
from your local Electrolux Outdoor Products
Approved Service Centre.
2. Only use extension cables specifically
designed for outdoor use.
ENGLISH - 1