McCulloch 964815301 Trimmer User Manual


 
Caring for your Hedgetrimmer
Cleaning (J)
1. Using a soft brush - remove debris from all
air intakes and cutting blade.
2. Wipe over surface of your hedgetrimmer
with a dry cloth.
IMPORTANT
Never use water for cleaning your hed-
getrimmer. Do not clean with chemicals,
including petrol, or solvents - some can
destroy critical plastic parts.
Lubricating the Cutting Blade
For easier operation and longer life, lubricate
the cutter blades before and after use. Apply
the oil so that it runs between the two blades.
See Pic K.
At the end of the Cutting Season.
1. Clean your Hedgetrimmer thoroughly.
2. Check that all nuts and bolts are secure.
3. Visually inspect the Hedgetrimmer for any
worn or damaged parts, contact your local
Service Centre if any parts require
replacement.
To store your Hedgetrimmer
The Hedgetrimmer blade cover/storage
holder is provided with 2 hanging slots for
storing the Hedgetrimmer on the wall.(See
Pic L)
Ensure the blade cover/storage holder is
fitted before storage.
1. The use of 2 number 10 screws (40mm in
length) and the appropriate wall fixing
plugs is recommended
2. Drill 2 holes 47mm horizontally apart.
3. Fit wall plugs.
4. Fit screw ensuring enough length is avail-
able for secure location into hanging slot.
Your mains cable can be stored with the
blade cover/storage holder fitted. (Pic M &
N)
Store in a dry place where your
Hedgetrimmer is protected from damage.
J
K
M
N
L