Filter
Top Products
7
Mowing
SWEEPING -- Thefanning actionof therotat-
ing line can be used f or a quick and easy
clean up. Keep the line parallel to and above
the surfaces being swept and move the tool
from side to side.
Sweeping
MAINTENANCE
WARNING: Disconnect the spark
plug before performing maintenance except
for carburetor adjustments.
CHECK FOR LOOSE
FASTENERS AND PARTS
S Spark Plug Boot
S Air Filter
S Housing Screws
S Assist Handle Screw
S Debris Shield
CHECK FOR DAMAGED OR
WORN PARTS
Contact an authorized service dealer for re-
placement o f damaged or worn parts.
S ON/OFF Switch -- Ensure ON/OFF switch
functions properly by moving the switch to
the OFF position. Make sure engine stops;
then restart engine and continue.
S Fuel Tank -- Discontinue use of unit if fuel
tank shows signs of damage or leaks.
S Debris Shield -- Discontinue use of unit if
debris shield is damaged.
INSPECT AND CLEAN UNIT AND
LABELS
S After each use, inspect complete unit for
loose or damagedparts. Clean th eunitand
labels using adamp cloth with a mild deter-
gent.
S Wipe off unit with a clean dry cloth.
CLEAN AIR FILTER
A dirty air filter decreases engine perform-
ance and increases fuel consumption and
harmful emissions. Always clean after e very
5 hours of operation.
1. Clean the cover and the area around it to
keep dirt from falling into the carburetor
chamber when the cover is removed.
2. Remove parts as illustrated.
NOTE: Donotcleanfilteringasolineorother
flammablesolventtoavoid creatingafirehaz-
ard or producing harmful evaporative emis-
sions.
3. Wash the filter in soap and water.
4. Allow filter to dry.
5. Replace parts.
Button
AirFilterCover
Air Filter
REPLACE SPARK PLUG
Replace the spark plug each year to ensure
the engine starts easier and runs better. Set
spark plug gap at 0,6 mm . Ignition timing is
fixed and nonadjustable.
1. Twist, then pull off spark plug boot.
2. Removespark plugfrom cylinderanddis-
card.
3. Replace with Champion RCJ-6Y spark
plug and tighten securely with a 19 mm
socket wrench.
4. Reinstall the spark plug boot.
SERVICE AND ADJUSTMENTS
REPLACING THE LINE
1. Move the ON/O FF switch to the OFF
position.
2. Disconnect the spark plug lead wire.
3. Removespool byfirmly pulling ontapbut-
ton. Clean entire surface of hub and
spool.Replacewithapre-wound spool,or
cut two lengthsof 4meters of 2mmdiam-
eter McCullochr brand line.
WARNING: Never use wire, rope,
string, etc.,whichcanbreak offandbecomea
dangerous missile.
4. Insert ends of the line about 1cm into the
small hole on the inside of spool.