McCulloch 433B Brush Cutter User Manual


 
16
TROUBLE CAUSE REMEDY
Engine will not
start.
1. ON/STOP (I/0) switch in
STOP position.
2. Engine flooded.
3. Fuel tank empty.
4. Spark plug not fir ing.
5. Fuel not reaching
carburetor.
6. Carburetor requires
adjustment.
1. MoveON/STOP (I/0) switch to ON (I)
position.
2. See “Starting a Flooded Engine” in
Operation Section.
3. Fill tank with correct fuel mixture.
4. Install new spark plug.
5. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
6. Contact an authorized service dealer.
Engine will
not idle
properly.
1. Carburetor requires
adjustment.
2. Crankshaft seals worn.
3. Compression low.
1. See “Carburetor Adjustment” in
Service and Adjustments Section.
2. Contact an authorized service dealer.
3. Contact an authorized service dealer.
1. Air filter dirty.
2. Spark plug fouled .
3. Carburetor requires
adjustment.
4. Carbon build-up on
muffler outlet screen.
5. Compression low .
Engine will not
accelerate,
lacks power,
or dies under
a load.
1. Clean or replace air filter.
2. Clean or replace plug
and regap.
3. Contact an authorized service dealer.
4. Contact an authorized service dealer.
5. Contact an authorized service dealer.
Engine
smokes
excessively.
1. Choke partially on.
2. Fuel mixture incorrect.
3. Air filter dirty.
4. Carburetor requires
adjustment.
1. Adjust choke.
2. Empty fuel tank and refill with
correct fuel mixture.
3. Clean or replace air filter.
4. Contact an authorized service dealer.
Engine runs
hot.
1. Fuel mixture incorrect.
2. Spark plug incorrect.
3. Carburetor requires
adjustment.
4. Carbon build-up on
muffler outlet screen.
1. Empty fuel tank and refill with
correct fuel mixture.
2. Replace with correct spark plug.
3. Contact an authorized service dealer.
4. Contact an authorized service dealer.
WARNING: Alwaysstopunitanddisconnectsparkplugbeforeperformingallo fthe
recommended remedies below except remedies that require operation of the unit.
TROUBLESHOOTING TABLE