McCulloch 115376727 Trimmer User Manual


 
10
OPERATION
KNOW YOUR TRIMMER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT.
Compare the illustrations with your unit to familiarize yourself with the location of the various controls
and adjustments. Save this manual for future reference.
Line Limiter
Blade
Primer Bulb
Assist Handle
Throttle Trigger
Start
Lever
Spark
Plug
Shield
Trimmer
Head
Shaft
Muffler
ON/STOP
Switch
Coupler
Starter handle
ON/STOP SWITCH
The ON/STOP switch is located on the trigger
handle and is used to stop the engine. To stop
the engine, push and release the engine ON/
STOP switch.
PRIMER BULB
The PRIMER BULB removes airfrom thecar-
buretor and fuel lines and fills them with fuel.
This allows you to start the engine with fewer
pulls on the starter rope. Activate the primer
bulb by pressing it and allowing it to return to
its original form.
START LEVER
The ST ART LEVER helps to supply fuel to the
engine to aid in starting. Activate the starting
system by moving the start leve r to th e START
position. DO NOT squeeze the throttle trigger
until the engine has started and runs. After the
engine starts, allow the engine to warm--up
10--15 seconds, then fully squeeze the throttle
trigger to deactivate the starting system.
COUPLER
The COUPLER enables optional attach-
ments to be installed on the unit.
BEFORE STARTING ENGINE
WARNING: Be sure to read the fuel
information in the safety rules before you begin.
If you do not understand the safety rules, do not
attempt to fuel your unit. Call 1-800-554-6723.
FUELING ENGINE
WARNING: Remove fuel cap slowly
when refueling.
HELPFUL TIP
To obtain the correct oil mix
ratio, pour 3.2 ounces of
2-- cycle synthetic oil into
one gallon of fresh gas.
This engine is certified to operate o n
unleaded gasoline. Before oper a tion,
gasoline must be mixed with a good quality
synthetic 2-cycle air-cooled engine oil
designed to be mixedat aratio of 40:1. A 40:1
ratiois obtainedby mi xing3.2fluid ounces (95
ml) of oil with 1 gallon (4 liters) of unleaded
gasoline. Pour the entire contents of the 3.2
ounce (95 ml) container of oil into 1 gallon (4
liters) of gasoline to achieve the proper fuel
mixture. DO NOT USE automotive or marine
oil. These oils will cause engine damage.
When mixing fuel follow the instructions
printed on the container. Once oil is added to
gasoline, shake container momentarily to
assure that the fuel is thoroughly mixed.
Always read and follow the safety rules
relating to fuel before fueling your unit.
CAUTION: Never use straight gasoline in
your unit. This will cause p ermanent engine
damage and void the limited warranty .
FUEL REQUIREMENTS
This engine requires the use of minimum 87
octane [R+M]/2 clean gasoline.
IMPORTANT
Use of alcohol blended fuels (called gasohol or
using ethanol or methanol) can cause major en-
gine performance and durability problems.