Filter
Top Products
While facing the wire connecting portions
to Pipe 25 side, connect the Lead wires
(black, Yellow) to Terminal. And then,
connect Lead wire (red) to Terminal.
Fig. D-5
Fig. D-6
Wiring to Terminal
Wiring in Handle (L)
Pipe 25 side
Terminal
Wire connecting
portion
Handle (L) side
Rib
Power supply cord unit
LED warning lamp
Pass Lead wire (red) between Terminal and
Switch through the space between Rib A
and Rib B.
Lead wire
(black)
Lead wire
(Yellow)
Lead wire
(red)
UR140D, UR180D
Rib A
Terminal
Switch
Rib B
Lead wire (red)
Wiring diagram
P 11/ 12
Put LED warning lamp’s lead wire (red)* on
its lead wire (black) and insert them into
the groove in Handle (L).
*using Lead wire (white) for some countries
Rib
1. Come out at least 5 mm long portion of
Power supply cord unit from the lower
edge of Labyrinth figured lead holders.
But the sheath end must not go over Rib A.
2. Make sure that Power supply cord unit is
fixed in Labyrinth figured lead holders.
at least
5 mm
Sheath