Filter
Top Products
8
009286
Attaching the chip receiver (accessory) on the tool when
trimming the hedge straight can avoid cut off leaves'
being thrown away.
009287
To cut a hedge side evenly, it helps to cut from the
bottom upwards.
009288
Trim boxwood or rhododendron from the base toward
the top for a nice appearance and good job.
009289
Installing or removing chip receiver
(accessory)
CAUTION:
• Always be sure that the tool is switched off and
unplugged before installing or removing chip
receiver.
NOTE:
• When replacing the chip receiver, always wear
gloves so that hands and face does not directly
contact the blade. Failure to do so may cause
personal injury.
• Always be sure to remove the blade cover before
installing the chip receiver.
• The chip receiver receives cut-off leaves and
alleviates collecting thrown-away leaves. This can
be installed on either side of the tool.
1
2
3
4
009290
Press the chip receiver on the shear blades so that its
slits overlap with the nuts on the shear blades. At this
time, make sure that the chip receiver does not contact
branch catcher at the top of the shear blades.
1
2
009291
At this time, the chip receiver needs to be installed so
that its hooks fit into grooves in the shear blade unit.
1
2
3
009292
To remove the chip receiver, press its lever on both sides
so that the hooks are unlocked.
1. Hooks
2. Fit the hooks
into groove
3. Grooves
1. Nut
2. Branch catcher
1. Press
2. Chip receiver
3. Nut
4. Shear blade