Filter
Top Products
Installing or removing
vise
assembly
To install the
vise
assembly, insert the shaft
of
the
vise
assembly into the hole in the
housing
as
far
as
it
will go. The shaft of the
vise
assembly will be grasped by the stop-
per automatically. Make sure that the
vise
assembly cannot be removed even though
you try to pull
it
out.
To remove the
vise
assembly, raise the stopper and then pull the
vise
assembly out while
turning the
vise
assembly.
CAUTION
:
Do
not use the
vise
assembly when cutting pipes up to
25
mm
(1")
in diameter or thin
wall pipes.
Securing tool to workpiece
Turn the
vise
handle counterclockwise until
approx.
25
mm
(1")
threaded portion
is
visible. Place the
vise
assembly on the part
of the workpiece which will not fall off
after the cut
is
made. Wrap the chain around
the workpiece and hook the chain onto the
chain hook
on
the
vise
assembly while
maintaining tension on the chain. Turn the
vise handle clockwise to tighten the chain.
Switch action
Tool speed
is
increased by increasing pres-
sure on the trigger.
To
start the tool,
simply pull the trigger.
Release
the trigger
to stop. A speed control screw
is
provided
so
that maximum tool speed can be limited
(variable). Turn the speed control screw
clockwise for higher speed, and counter-
clockwise for lower speed.
CAUTION
:
Before plugging in the tool, always check to
see
that the trigger switch actuates properly
and returns to the
"OFF"
position when released.
Overload protector
The overload protector automatically cuts out to break the circuit whenever heavy work
is
prolonged. If this occurs, release the trigger switch and withdraw the blade from the
workpiece. Press the restart button to resume operation.
6