8
Fuel and oil mixture
- The engine of the hedge trimmer is a high-efciency two-stroke engine.
It is run with a mixture of fuel and two-stroke engine oil. The engine is designed
for unleaded regular fuel with a min. octane value of 91 ROZ.
In case no such fuel is available, you can use fuel with a higher octane value.
This will not damage the engine, but may cause poor operating behaviour.
A similar situation will arise from the use of leaded fuel.
To obtain optimum engine operation and to protect your health and the
environment, only unleaded fuel should be used!
- For lubricating the engine use a two-stroke engine oil (quality grade: TSC-3),
which is added to the fuel.
The engine has been designed for use with MAKITA two-stroke engine oil and a
mixture ratio of 50:1 only to protect the environment. In addition, a long service
life and a reliable operation with a minimum emission of exhaust gases is
guaranteed. It is absolutely essential to observe a mixture ratio of 50:1 (MAKITA
2-stroke engine oil), otherwise the reliable function of the hedge trimmer cannot
be guaranteed.
- The correct mixture ratio:
Gasoline: Specied two-stroke engine oil = 50 : 1 or
Gasoline: Other manufacturer’s two-stroke engine oil = 25 : 1
recommended
NOTE: For preparing the fuel-oil mixture, rst mix the entire oil quantity with half of
the fuel required in an approved canister which meets or exceeds all local
code standards. Then add the remaining fuel.
Thoroughly shake the mixture before lling it into the hedge trimmer’s tank.
Do not add more engine oil than specied to ensure safe operation. It will
only result in a higher production of combustion residues which will pollute
the environment and clog the exhaust channel in the cylinder as well as the
mufer. In addition, the fuel consumption will rise and the performance will
decrease.
Handling petroleum products
Utmost care is required when handling fuels. Fuels may contain substances similar
to solvents. Refuel either in a well ventilated area or outdoors. Do not inhale fuel
vapors, avoid any contact of fuel or oil with your skin.
If your skin comes in contact with these substances repeatedly and for an extended
period of time, it will desiccate.
Various skin diseases may result. In addition, allergic reactions are known to occur.
Eyes can be irritated by contact with oil, fuel etc.
If oil, fuel, etc., comes into your eyes, immediately wash them with clear water.
If your eyes are still irritated, see a doctor immediately!
FUELS/REFUELING
Observe the Safety Instructions on page 4.
1,000 cm
3
(1 litter)
5,000 cm
3
(5 litter)
10,000 cm
3
(10 litter)
20 cm
3
40 cm
3
100 cm
3
200 cm
3
200 cm
3
400 cm
3
Gasoline Oil
+
50:1
50:1 25:1