Filter
Top Products
30
STOP
7
2
3
1
4
6 5
A
B
Cleaning the brake band and sprocket interior
CAUTION: Before doing any work on the guide bar or
chain, always switch off the engine and pull the plug cap
off the spark plug (see "Replacing the spark plug"). Always
wear protective gloves!
CAUTION: Start the chain saw only after having assem-
bled it completely and inspected.
Remove the sprocket guard (1) (See "PUTTING INTO OPE-
RATION" figs. B) and clean the interior with a brush.
Turn the chain tensioning screw (2) to the left (counter-clock-
wise) until pin (3) of the chain tensioner is underneath the
threaded pin (4).
Remove the chain (5) and guide bar (6).
NOTE:
Make sure there are no residues or foreign matter remaining in
the oil guide groove (7) or on the chain tensioner (3).
For replacing the guide bar, chain, and sprocket see "PUTTING
INTO OPERATION".
NOTE:
The chain brake is a very important safety device and like
any other component subject to normal wear and tear.
Regular inspection and maintenance are important for
your own safety and must be done by a MAKITA service
center.
SERVICE
Cleaning the guide bar
CAUTION: Protective gloves must be worn.
Regularly inspect the bearing surfaces of the guide bar for
damage, and clean them with a suitable tool.