Filter
Top Products
Installing saw chain and guide bar
CAUTION
:
Always be sure that the tool
is
switched off and unplugged before installing saw chain and
guide bar.
Use the socket wrench to loosen the hex
bolt holding the chain cover. Remove the
chain cover.
1
Fig.
2
Fit one end of the chain over the sprocket
and the other over the end of the guide
bar. Notice that the cutters must be in the
direction of the arrow in Fig.
3
and
4.
Keep the chain in the guide bar grooves.
Adjust
pin
Sprocket
\
Fig.
3
Cutter
dT--
Install the guide bar
so
that the lower hole in the guide bar
is
just over the adjusting pin.
Install the chain cover and tighten the hex bolt only tight enough to hold the guide bar
temporarily.
8