Logan Graphic Products T300 Trimmer User Manual


  Open as PDF
of 4
 
Identification
Board
A. Squaring Arm
B. Squaring Arm Stop
C. Lifter
D. Cutting Head
E. Cutting Bar
F. Handle Bar
Safety
• Remove blades when servicing
machine.
• Do no place your fingers near
blade when using machine.
• Be sure lifter bar is down when
cutting.
• Do not force cutting head if stuck.
Assembly
Attaching Squaring Arm & Stop
1. Use two screws to attach squaring arm to
board.
2. Slide stop on to squaring arm. (Fig. 1)
Blade Installation
1. With handle bar in down position, pull out
plunger pin & rotate blade holder back.
Loosen blade holding screw (Fig. 2)
2. Slide blade into slot under “Blade” label.
(Fig. 3)
3. Tighten screw & rotate blade holder back
until plunger pin releases to safety position.
Depth Setting
1. Determine desired depth setting using
Blade Depth Settings chart. (Fig. 4)
2. Rotate depth adjustment knob to desired
number setting. (Fig. 5)
Fig. 1
Fig. 5
Fig. 3
Fig. 2
Fig. 4
2
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 www.logangraphic.com
Total Trimmer
Instruction Manual
Model T300 & T360
Head
G. Blade Knob
H. Depth Adjustment
Knob
I. Plunger Pin
J. Blade Holder
B
C
D
E
F
A
Blade Holding Screw
G
H
I
J
BLADE DEPTH
SETTINGS
1 1/8” 3mm
2 3/16 - 1/4” 5-6mm
3 3/8 - 1/2” 9-12mm
Use Blade#267
 previous next