Filter
Top Products
During Operation
1. Tractor should be equipped with ROPS and
seat belt during operation.
2. Do not allow anyone to operate this machine
who has not been properly trained in its safe
operation.
3. Do not allow children to operate the implement.
4. Never dismount from a moving tractor.
5. Put tractor in park, turn off engine, remove key
and allow moving parts to stop before making
any adjustment to the implement.
6. Do not leave the tractor or the implement with
the engine running.
7. Never allow passengers.
8. Travel slowly over rough terrain and be alert to
holes and gullies.
9. Loose fitting clothing should not be worn as it
may catch in moving parts.
10. If a hydraulic leak develops, correct it immedi-
ately. Escaping hydraulic oil can have ex-
tremely high pressure. A stream if high-
pressure oil may easily penetrate the skin as
with modern needle less vaccination equip-
ment, but with the exception that hydraulic fluid
may cause blood poisoning. It is imperative
that the connections are tight and that all lines
and pipes are in good condition. If the escap-
ing hydraulic fluid causes an injury, see a doc-
tor at once! Use a piece of cardboard or wood
to detect leaks of hydraulic oil under pressure.
Be sure to relieve all hydraulic pressure before
disconnecting any lines or pipes between the
implement and the tractor hydraulic system.
Keep all guards and shields in place.
11. Do not turn tractor in too tight; implement may
ride up on wheels causing machine and bodily
damage.
CONTACT WITH OVERHEAD POWER LINES
CAN CAUSE SEVERE ELECTRICAL BURNS OR
DEATH FROM ELECTROCUTION. MAKE SURE
THERE IS ENOUGH CLEARANCE BETWEEN
COMPONENTS AND OVERHEAD POWER
LINES. DO NOT LOAD NEAR POWER LINES.
DO NOT CLIMB NEAR POWER LINES.
THIS MACHINERY CAN BE VERY DANGER-
OUS AND CAN CAUSE SEVERE INJURY OR
DEATH BY ENTANGLEMENT. READ AND UN-
DERSTAND MANUAL BEFORE ATTEMPTING
TO OPERATE IT.
After Operation
1. Detach and store implement in an area where chil-
dren normally do not play. Stabilize implement by
using suitable supports and block wheels.
2. Be alert to traffic when crossing or operating near
roadways. Always maintain complete control of the
machine. Know your state and local laws concerning
highway safety and regulations. Comply with these
laws when transporting machinery.
3. Limit transport speed to 20 mph. Transport only with
an appropriate vehicle of sufficient size and horse-
power. Refer to Attaching Reel Mower to the tractor
under the “Operating Instructions” section.
During Maintenance
1. Securely block up implement before doing any
work underneath it.
2. Tire changing can be dangerous and should be
performed by trained personnel using the correct
tools and equipment.
3. Do not re-inflate a tire that has been run flat or
seriously under inflated. Have it checked by quali-
fied personnel.
4. When removing and installing wheels, use wheel
handling equipment adequate for the weight in-
volved.
5. Before greasing and oiling implement, shift tractor
into park, disengage PTO, turn off engine, remove
key and allow moving parts to stop.
6.
After repairing or adjusting, make sure all tools
and parts are removed from the implement before
attempting to operate it.
NOTE
DURING BACKLAPPING OR SHARPENING, CARE-
FULLY FOLLOW THE INSTUCTIONS THAT ARE
FURNISHED WITH THE SHARPENING EQUIPMENT.
WARNING
WARNING
7