Filter
Top Products
vered "wheelbarrow fashion."
1. Keep all nuts, bolts and screws tight.
2. Never store the machine filled with fuel inside a
building or in a confined space where fumes may be
susceptible to sparks or an open flame.
3. Refer to the instructions manual for important
details if the product is to be stored for an extended
period of time.
4. Check the tightness of the blade nut prior to each
use.
5. Prior to each use, lubricate cutter head shaft
(P/N 131), cutter head bracket (P/N l00-C), and key
(P/N 138) at slip rotation points every 8 hours
6. Prior to each use, check to see that set screws on
pulley are tight, and guards are in place.
NOTE: The belt guard is an important safety feature
and is vital to the proper operation of the edger.
7. Grease cutter head every 25 hours. Use Lithium
#0 grease (P/N 4042). Add grease until grease starts
to squeeze through the bearing.
Loose set screws can cause
damage to shaft and pulley.
Improper maintenance will void warranty.
USER MAINTENANCE
INSTRUCTIONS
WARNING: The engine on your Pro Honda
Edger is not equipped with a spark arrester and
if machine is to be used on any forest-covered,
brush-covered, or grass-covered unimproved
land, before using on such land a spark arrester
must be added to the muffler. The arrester must
be maintained in effective working order by the
operator. In the State of California, the above is
required by law (Section 4442 of the California
Public Resources Code). Other states may have
similar laws. Federal laws apply on federal
lands. See your Authorized Honda Service
Center for spark arrester muffler options.
CAUTION
▲
!
▲
!
NOTE: The belt guard is vital to the proper
operation of the edger. The belt guard is not just
a safety feature!
Fig. 5
10