Filter
Top Products
10
RTR12 & RTA12 Series (Serial No. 884764-) Rotary Tillers 311-785M
8/12/14
Section 1: Assembly and Set-Up
Table of Contents
Reverse Rotation (RTR) Rotary
Tillers
The following are assembly instructions for reverse
rotation tillers (RTR12 Series). See page 12 for standard
rotation tillers (RTA12 Series).
IMPORTANT: Parking stand (#1) and wire retaining
pin (#7) must be installed at the correct height
before continuing. See “Parking Stand Installation”
on page 9 for special instructions.
RTR Parking Stand and Front Deflector Assembly
Figure 1-2
30348A
RTR Front Deflector Assembly
Refer to Figure 1-2:
1. Remove 3/8"-16 x 1 1/2" bolts (#3), flat washers (#5),
lockwashers (#6), hex nuts (#4) and both front
deflector mounting bars (#2) from tiller frame.
2. Insert 3/8"-16 x 1 1/2" GR5 hex head bolts (#3)
through flat washers (#5), upper mount bar (#2A),
front rubber deflector (#8) and mounting holes “A”.
3. Secure rubber deflector and upper mounting bar with
lower mount bar (#2B), lock washers (#6) and hex
nuts (#7).
4. Tighten hex nuts to the correct torque.