Filter
Top Products
20
Section 4: Maintenance & Lubrication
PS1548 & PS1572 Primary Seeder 313-164M
7/22/05
Land Pride
Table of Contents
Section 4: Maintenance & Lubrication
Maintenance
Proper servicing and adjustment is the key to the long life
of any farm implement. With careful and systematic
inspection, you can avoid costly maintenance, time and
repair.
1. After using your seeder for several hours, check all
bolts to be sure they are tight.
2. After transporting your seeder for several hours,
check all bolts and nuts to be sure they are tight.
Storage
1. At the end of the working season or when your
Primary Seeder will not be used for a long period, it is
good practice to clean off any dirt or grease that may
have accumulated on the seeder and any of the
moving parts.
2. Be sure that the seed box is completely cleaned
before storing.
3. The square bore of the seed cup drive sprocket hub
should be oiled to prevent seizing. Squirt oil on to the
square feed cup shaft and move seed cup adjustment
lever back and forth in order to get the oil back into the
square.
4. Lubricate all fittings as indicated.
5. When in storage, lower the seeder with rollers on a
board or hard surface and adjust the parking stand or
tongue jack.
6. Repaint parts where paint is worn or scratched to
prevent rust.
7. Replace all damaged or missing decals.
8. Store the seeder inside if possible. Inside storage will
reduce maintenance and make for a longer seeder
life.
9. Inspect the Primary Seeder for loose, damaged or
worn parts and adjust or replace if needed.
Lubrication
Feed Cup Drive Shaft
Type of Lubrication: Oil
Quantity = Generously
Roller Bearings
Type of Lubrication: Multi-Purpose
Quantity = Coat Generously
12957
12958
50
Multi-purpose
spray lube
Multi-purpose
grease lube
Multi-purpose
oil lube
Intervals at which
lubrication is required
Lubrication
Legend
50
25