Filter
Top Products
16
Section 6: Features and Benefits
Series No FM3072, FM3088 & FM4088 Flail Mowers 309-106M
7/06/06
Land Pride
Table of Contents
Section 6: Features and Benefits
FM30 & FM40 Series Flail Mowers
Features Benefits
Key widths 30 Series: 72”, 88”; 40 Series: 88”
Gearbox HP Rating 35 - 80 HP
7 3/4” Left & right-screw type
offset hitch
Easily offset the hitch for roadsides or getting under tree limbs.
ACME threads on offset ACME threads are deeper allowing for easy screwing adjustment.
Gearbox Warranty One year on all components.
540 RPM cast iron gearbox
with over-running clutch
Enables the rotor to free swing to a stop when the tractor PTO has been turned off.
1/2” – 6” Cutting height Variable cutting heights for many uses.
1” Cutting capacity
(30 Series)
2” Cutting capacity
(40 Series)
Cut saplings when used in a rough setting.
40 Series is good for chopping up tree trimmings.
Fine cut knives
(30 Series)
Forged hammer knives (40
Series)
Heavy enough to cut 1” material, yet fine enough to groom a yard.
Forged hammers are just right for chopping up prunings up to 2” thick, but will also groom
grass in a very acceptable manner.
Brush rake teeth
(40 Series)
The adjustable brush rake teeth continually push prunings into the knife path for repeated
chopping action.
5 1/2” Rotor diameter Large rotor is able to take rough conditions.
Reverse rotor rotation Brings the cut material up and over which allows it to be dispersed more evenly.
Cat. 4 driveline Heavy-duty driveline matches up with HP range as well as potential conditions.
3 ‘C’ Section belts ‘C’ Section belts have more surface to pulley contact, and fits deeper in the groove.
3/16” Deck thickness Allows the mower to handle rough conditions.
Baffles on top inside of deck Keeps the cut material from clumping together, ensuring an even distribution of clippings.
Hinged rear gate Can be opened for easier discharge in heavy conditions, or left closed for greater mulching
capabilities.
Height adjusting roller Rear height adjusting roller with greaseable bearings and tapered ends to prevent gouging
during turns.
Scrapers Standard scrapers on rear height adjusting roller, keeps roller clean for consistent cutting
height
High knife tip speed Knife tip speed of 8,705 fpm for cleaner cut.