Filter
Top Products
7
Section 1: Assembly and Set-Up
12/06/11
CA2560 & CA2572 Core Aerators 325-020M
Table of Contents
Hitch Assembly
Figure 1-1
18978
Section 1: Assembly and Set-Up
Torque Requirements
Refer to “Torque Values Chart For Common Bolt Size”
on page 19 to determine correct torque values when
tightening hardware.
Assembly Instructions
Review all safety instructions printed in this manual
before assembling the Aerator.
Hitch Assembly
Refer to Figure 1-1:
1. Install upper hitches (#1) & (#2) to frame using
1/2" x 1 1/2" bolts (#3), lockwashers (#4) & nuts (#5).
2. Install bushing (#6) between upper hitches with
3/4" x 4" long bolt (#7), lockwasher (#8) and nut (#9).
3. Tighten all hardware using torque requirements on
page 19.
NOTE: Do not tighten the hardware until assembly
is complete.
General Description
This unit is shipped partially assembled. It is the
Dealerships responsibility to finish the assembly.
Tools Required
•
Lift truck or hoist capable of handling the load
• Wrench set
• Socket set
Unloading Instructions
!
CAUTION
Never allow anyone under the unit while unloading.
Remove crated Aerator from the flat bed trailer with a
lifting devise designed for handling the load. Gently set
the crate down on a smooth flat work surface. Carefully
uncrate the unit to protect against scratching and/or
damaging the paint.