Filter
Top Products
6/30/05
27
Section 6: Maintenance
4400EX Heavy Duty Off Road Utility Vehicle 720-051M
Table of Contents
High Altitude Carburetor Kit
Gondo vehicles shipped from the factory are equipped
with carburetors designed to operate efficiently between
0 and 4,999 feet. Carburetor change over kits for different
altitudes may be purchased from your nearest Land Pride
Dealer. The following kits are available:
Elevation Carburetor Kit No.
0’ - 7,999’ Engine Standard
8,000’ & up 24755125-S
Power Steering Belt
Refer to Figure 6-5 & Figure 6-6
Power steering belt and pump are positioned behind the
engine and are protected by a shield. Do not remove
shield except to service the belt and always replace
shield after servicing the belt.
Replace power steering belt when it shows signs of
severe cuts, tears, excessive weather checking and
cracking or burns caused by slipping. Slight raveling of
belt covering does not indicate failure. Trim ravelings with
a sharp knife.
Inspect belt pulley grooves and flanges for wear. A new
belt, or one in good condition, should never run against
bottom of pulley groove. Replace pulley when this is the
case, otherwise belt will lose power and slip excessively.
Never pry a belt to get it on a pulley as this will cut or
damage the fibers of the belt covering.
Keep oil and grease away from belts and never use belt
dressings. Any of these will destroy the belt composition in
a very short time.
!
CAUTION
Make certain to keep fingers from getting caught between belt
and pulley when rotating belt over pulley.
Replace power steering belt as follows:
1. Prepare vehicle for maintenance as outlined in steps
1-6 on page 22.
2. Safely secure the seat console in the raised position.
3. Disconnect negative battery cable.
4. Safely secure cargo box and seat console in the up
position to prevent injury.
IMPORTANT: The air-fuel mixture in carburetors
modified for high elevation is too lean when operating
at elevations below 5,000 feet. Operating engines with
modified carburetors below 5,000 feet can result in
engine overheating and serious engine damage.
Return carburetor to original factory specifications
when operating at low elevations.
Figure 6-5
Refer to Figure 6-5
5. Remove bolts securing belt cover and remove cover.
Figure 6-6
Refer to Figure 6-6
6. Loosen belt take-up bolt and hand squeeze belt
together. This should allow room to remove the belt.
7. Remove belt by rolling it off over the drive pulley and
then lifting it up off the driven pulley.
8. Reinstall new belt by placing it over the driven pulley
and then rolling it over the drive pulley.
9. Re-tension power steering belt and tighten take-up
bolt.
10. Reinstall belt cover and fasteners.
11. Reconnect battery negative cable.
12. Remove blocks securing cargo box up and lower
cargo box.
Power Steering Shield
21346
21353
Drive Pulley
Take-up Bolt & Slot
Driven Pulley
Power Steering
Pump