Filter
Top Products
La Crosse Technology Page 7
Temperature Trend Arrows
The indoor and outdoor temperature trend arrows will update every 30 minutes or less. These
trends represent temperature changes over the past three hours.
UP: Temperature rose more than 2°F/1°C in the past three hours
RIGHT: Temperature has not changed more than 2°F/1°C in the past three hours
DOWN: Temperature fell more than 2°F/1°C in the past three hours
Outdoor Temperature Flashing
Low battery icon present in the outdoor temperature area:
1. Change batteries in the transmitter, and press the TX button.
2. Hold the SENSOR SEARCH button for 3 seconds and the Temperature
Station will search for the outdoor transmitter again.
End of Transmission Range:
1. Move the transmitter closer to the Temperature Station.
2. Avoid obstructions in the signal path.
3. Keep transmitter and Temperature Station away from electronics.
Install Batteries in the Temperature Station
1. Slide tab down and pull out to remove battery cover.
2. Install two new AA batteries according to the polarity markings.
• Do Not Mix Old and New Batteries
• Do Not Mix Alkaline, Lithium, Standard or Rechargeable Batteries
If the Temperature Station does not display indoor temperature after 60
seconds, remove adapter and batteries and wait for at least 60 seconds
before repeating the setup process.
Install Batteries in the Outdoor Transmitter
1. Slide the battery cover down, then lift off the front of the transmitter.
2. Insert two new AA batteries into the transmitter. Observe the correct polarity (see marking
inside battery compartment).
3. Keep transmitter 5-10 ft. from the Temperature Station during setup.
4. After 15 minutes, if the outdoor temperature shows on the Temperature Station, you can
move the outdoor transmitter outside to a shaded location within range of the Temperature
Station.
Care and Maintenance
• Do Not Mix Old and New Batteries
• Do Not Mix Alkaline, Lithium, Standard or Rechargeable Batteries
• Do not expose the Temperature Station to extreme temperatures, vibration or shock. Keep dry.
• Clean Temperature Station with a soft damp cloth. Do not use solvents or scouring agents.
• The Temperature Station is not a toy. Keep it out of reach of children.
• The Temperature Station is not to be used for medical purpose or for public information. It is for home
use only.
• The specifications of this Temperature Station may change without prior notice.
• Improper use or unauthorized opening of housing will void the warranty.
• If the Temperature Station does not work properly, change the batteries.
Position the Temperature Station
Choose a location for the Temperature Station that is within range of the outdoor transmitter. The
Temperature Station has a built in base stand to sit on a table or desk.