Filter
Top Products
9
Interior
• Cleaning should always be followed by rinsing with clean,
warm water.
• Use a mild liquid detergent or all-purpose cleaner, following
label instructions. Rinse with clean water and dry completely
with a soft, lint-free cloth.
• A heavy-duty scrub sponge can be used with mild cleaning
products. Always rub in the direction of the grain.
• For small, difficult-to-clean areas, use Whirlpool Degreaser
(Part No. 31552), a commercial degreaser designed for
stainless steel. See “Requesting Assistance or Service” section
to order.
Burner caps and grate
• Clean with a brass bristle brush.
• Wash grate using mild detergent, warm water and degreaser.
• Rinse with clean water and dry with soft, lint-free cloth.
• Use Stainless Steel Cleaner & Polish (Part No. 4396095). See
“Requesting Assistance or Service” section to order.
Knobs, plastic and flange area around knobs
IMPORTANT: Do not use steel wool, abrasive cleaners, or oven
cleaner.
Do not soak knobs.
• Wash with mild detergent, using a soft cloth and warm water.
Rinse and dry.
Control panel graphics
IMPORTANT: Do not use steel wool, abrasive cleaners or oven
cleaner.
Do not spray cleaner directly onto panel.
Clean around the burner labels gently; scrubbing may remove
printing.
• Wash with mild detergent, using a soft cloth and warm water.
Rinse and dry.
Cleaning
General Tips
IMPORTANT: Before cleaning, make sure all controls are off
and the burners are cool. Always follow label instructions on
cleaning products.
For routine cleaning, wash with soap and water using a soft cloth
or sponge. Rinse with clean water and dry at once with a soft,
lint-free cloth to avoid spots and streaks.
Never use steel wool to clean the side burner, as it will scratch
the surface.
Stainless Steel
IMPORTANT: Do not use soap-filled scouring pads, abrasive
cleaners, Cooktop Polishing Creme, steel wool, gritty wash
cloths or paper towels.
Cleaners should not contain chlorine. Damage may occur to the
product finish.
Rub in direction of grain to avoid scratching or damaging the
surface.
Food spills should be cleaned as soon as entire Side Burner is
cool. Spills may cause permanent discoloration.
• Use Stainless Steel Cleaner & Polish (Part #4396095). See
“Requesting Assistance or Service” section to order.
• Use a mild liquid detergent or all-purpose cleaner according to
label instructions.
• Rinse with clean water and dry at once with soft, lint-free cloth
to avoid spots and streaks.
• Use vinegar to remove hard water spots. Rinse with water and
dry thoroughly.
• Use a glass cleaner to remove fingerprints.
IMPORTANT: Make sure gas supply is off and all control knobs
are in the “OFF” position. Make sure the Side Burner is cool.
Exterior
The quality of this material resists most stains and pitting,
providing that the surface is kept clean and protected.
• Apply stainless steel polish to all non-cooking areas before
first use. Re-apply after each cleaning to prevent permanent
damage to surface.
• Cleaning should always be followed by rinsing with clean warm
water.
• Wipe the surface completely dry with a soft cloth.
• For tough spots or baked-on grease, use Whirlpool Degreaser
(Part No. 31552), a commercial degreaser designed for
stainless steel. See “Requesting Assistance or Service” section
to order.
Accessories
• L.P. Gas Conversion Kit -- Part No. 4396311
Cleaners
• Kitchen and BBQ Grill Degreaser -- Part No. 31617
• Stainless Steel Cleaner/Polish -- Part No. 31462