Filter
Top Products
9
Figure A Figure B
Figure C
STEP 4 Replace and tighten the (2) plugs and clean away any excess oil.
STEP 5 Remove Breather Plug (Located at top of side gearbox, See (FIG. D point
1 on next page), there is also a plug at the bottom (Located in the side of
the side gearbox) (FIG. D point 2 on next page) if oil comes out of lower
plug, replace plug immediately and go to STEP 6 , if oil doesn’t come out
of lower plug fill with gear oil (type GL5-85W 140) to lower plug.
STEP 6 Replace and tighten the plugs. Clean away any excess oil.
STEP 7 Grease the grease fitting on the "outboard hub, (Fig. E on next page) the
two (2) grease fittings on the PTO universal joints, the two (2) grease fit-
tings on the PTO safety shield and the inner surface portion of the PTO
shaft. See Figures F and G.
CAUTION:
DO NOT over fill gearbox. This could cause damage to oil seals and can cause per-
manent damage to the gearbox. This issue will not be covered under warranty.