Filter
Top Products
TO REPLACE BELT:
STEP 1 Remove top cover.
STEP 2 Loosen nut on adjustment pulley to allow for movement. (See Fig.
“D”)
STEP 3 Loosen nut on right side of L Bracket. (See Fig. “D”)
STEP 4 Loosen belt by moving adjustment pulley in opposite diection you
would to tighten belt.
STEP 5 Remove bolts (2) from hinge bolt gearbox plate from finishing
mower deck. (See Fig. E).
STEP 6 Loosen nuts (2) from hinge bolt gearbox plate.
STEP 7 Raise gearbox assembly and pull out belt.
STEP 8 See (Fig. D) for belt placement on pulleys.
STEP 9 Do step 4 & 5 under section: “TO ADJUST BELT” to tighten.
TO ADJUST BELT:
STEP 1 Remove top cover.
STEP 2 Loosen nut on adjustment pulley to allow for movement. (See Fig.
“D”)
STEP 3 Loosen nut on right side of L Bracket. (See Fig. “D”)
STEP 4 Turn nut on left side of L Bracket in counter clockwise direction until
belt is tight.
STEP 5 Retighten nut on right side of L Bracket and nut on adjustment pulley.
4 FT. REAR DISCHARGE FINISHING
MOWER ONLY
24