Filter
Top Products
9
STEP 6 Fill side gearbox using gear oil until the oil begins to overflow from the
check plug hole. See Figure F on next page.
STEP 7 Replace and tighten the 1/2‖ vent plug and the 1/8" check plug. Clean
away any excess oil. See Figure G on next page.
STEP 8 Grease the grease fitting on the "out-board hub," the two (2) grease fittings
on the PTO universal joints, the two (2) grease fittings on the PTO safety
shield and the inner surface portion of the PTO shaft. See Figures H, I
and J on next page.
CAUTION:
DO NOT over fill gearbox. This could cause damage to oil seals and can cause permanent damage
to the gearbox. This issue will not be covered under warranty.
Figure A
Figure B
Figure C
Figure D