Filter
Top Products
22
5-6-7 FT. FINISHING MOWER
TO REPLACE BELT:
STEP 1 Remove top cover.
STEP 2 Release adjustment spring.
STEP 3 Loosen nut on adjustment pulley to allow for movement. (See Figure ―D‖)
STEP 4 Loosen nut on right side of ―L‖ bracket. (See Figure ―D‖)
STEP 5 Loosen belt by moving adjustment pulley in opposite direction you would
to tighten belt.
STEP 6 Remove nuts (2) from hinged gearbox plate from finishing mower deck.
(See Figure E)
STEP 7 Loosen nuts (2) from hinged bolt gearbox plate.
STEP 8 Raise gearbox assembly and slip out belt.
STEP 9 See Figure D for belt placement on pulleys.
STEP 10 Do step 5 thru 7 under Section: "TO ADJUST BELT" to tighten.
TO ADJUST BELT:
STEP 1 Remove top cover.
STEP 2 Release adjustment spring.
STEP 3 Loosen nut on adjustment pulley to allow for movement. (See Figure D)
STEP 4 Loosen nut on right side of ―L‖ bracket. (See Figure D)
STEP 5 Turn nut on left side of ―L‖ bracket in counter clockwise direction until belt
is tight.
STEP 6 Re-tighten nut on right side of ―L‖ bracket and nut on adjustment pulley.
STEP 7 Re-hook adjustment spring. (See Figure ―D‖)