Filter
Top Products
8. if tapeholdsbottomdrawercoverto drawer
supports,removethetaperPulldrawerpartwayout,,
Reachin, pushthe rearoftheglassupand,at the
sametime,back,until it clearsfront-cornerretainers.
9. Tilt and remove the cover°
10, Tilt and remove the draweFo
After cleaning, replace drawers and covers in
reverse order. Reinstall the gasket at the rear of the
top drawer. Fit the end of
the plastic drawer support
into the slot on the gasket,
with the rubber gasket
flap facing you. Make
sure the gasket snaps
into place.
Then replace the light
panel by hanging top of
panel on upper pins and
pushing in at bottom_
Drain Opening in Freezer Compartment
During yearly cleaning,
remove the freezer bin
and flush a solution of
baking soda (one
teaspoon) and two cups
of hot (not boiling) water
through the drain line
with the help of a meat
baster. This will help
eliminate odor and reduce
the likelihood of a clogged drain lJne.
if drain becomes clogged, use a meat baster and
baking-soda.and-water solution to force the clog
through the drain line, Continue flushing until the
line is clear, then empty and replace the defrost
water pan immediately.
Condenser
The condenser is located
behind the base grille,, For
most efficient operation,
remove the base grille
(see page 3) and sweep
away or vacuum up dust
that is readily accessible_ This easy cleaning
operation should be done at least once a year.
Defrost Water Pan
The pan behind the base
grille should be cleaned
at least once a year. When
reinstalling the pan, firmly
push it ALL THE WAY IN
until it stops°
Behind Refrigerator
Take care moving your refrigerator away from the
wall All types of floor coverings can be damaged,
particularly cushioned coverings and those with
embossed surfaces. Pull the refrigerator straight out
and return it to position by pushing it straight in.
Moving refrigerator in a side direction may damage
floor covering or refrigerator.
Light Bulb Replacement
Unplug refrigerator before changing a light bulb.
Fresh Food Compartment--Upper Light
1. Pul! bottom of light
panel forward until panel
clears pins on rear wall,
then rotate panel
downward until tabs slide
out of slots in control
housing.
2. After replacing with standard 60-watt bulb,
reinstall light panel by (1) sliding tabs at front of light
panel into slots in control housing, and (2) flexing
rear portion of light panel over pins on rear wall,
Fresh Food Compartment_Lower Light
1. Remove light panel. See Storage Drawers, Step 3,
on page 12.
2. After replacing the 40-watt appliance bulb with a
same-size bulb, replace light panel by hanging top of
panel on upper pins, then pushing in at bottom.
Control Housing
Bulb compartment between freezer and fresh food
compartment controls contains two 7-watt screw-in bulbs.
1. Slide butb compartment
cover on underside of
control housing back
about 1/2 inch and it will
drop into your hand°
2. Replace with same-
size, same-type bulbs.
3. Line up tabs on cover with grooves in control
housing and slide cover forward into place°
Freezer Compartment
1. Remove shelf just
below light panel. (Shelf
will be easier to remove
if it is emptied first,)
2. Pull plastic light panel toward you_ (It will bend to
free tabs from grooves°)
3. After replacing with same size bulb, reinstall
panel and shelf.
13