Filter
Top Products
VERTICAL MOWER. DEPTH OF CUT ADJUSTMENT
Depth of cut changes as the height adjuster wheel pivot,
relative to the frame. Notches on the wheel height adjus-
ter allow ‘indexing’, ensuring the height adjustment is
equal at both ends of the Reel.
Fig.22
To adjust the depth of cut :
Note the position of the notches on the height adjusters,
they must be the same at both sides of the reel.
• Back-off both locknuts.
• Turn the height adjusters CW to increase, CCW to
decrease, the depth of cut.
• The notches are spaced 3/8 inch apart to enable
accurate adjustments.
• Tighten the locknuts.
DRIVE BELT ADJUSTMENT
Fig.23
The Drive Belts are tensioned by adjustable arms,
not telescopic as on the standard mowers.
To adjust the belt tension :
• Back-off the locknut.
• Turn the adjusting nut (viewed from front)CW to
increase, CCW to decrease, the belt tension.
• Tighten the locknut.
• Adjust to allow ½ inch deflection of the belt
midway between the sheaves.
Fig.22
Fig.23
26