Filter
Top Products
English 9
You can rectify minor faults yourself with
the help of the following overview.
If in doubt, please consult the authorized
customer service.
ƽ Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Repair works may only be performed by the
authorized customer service.
Î Check whether the voltage indicated on
the type plate corresponds to the volt-
age of the mains supply.
Î Check the mains connection cable for
damages.
Î Check setting at the spray lance.
Î Remove air from appliance before oper-
ation.
Switch on the appliance without mount-
ed spray lance and run it until the water
discharging from the trigger gun is free
of bubbles. Switch off appliance and
connect spray lance.
Î Check the water supply.
Î Pull out the fine filter in water connec-
tion using flat-nose pliers and clean with
running water.
Cause: Voltage reduction due to weak
mains supply or when using an extension
cable.
Î When switching on, first pull the lever of
the trigger gun and then switch the ap-
pliance switch to "I/ON".
Î Clean high-pressure nozzle: Remove
dirt and debris from the nozzle bore, us-
ing a needle and rinse through with wa-
ter from the front.
Î Check water flow quantity.
Î Slight leakage from the appliance pump
is normal. If the leakage increases con-
tact the authorized customer service.
Î Use spray lance with pressure regula-
tion (Vario Power).
Turn the spray lance to "Mix" position.
Î Check the settings at the detergent dos-
aging regulator.
Î Clean the detergent suction hose filter.
Î Check the detergent suction hose for
kinks.
Troubleshooting
Appliance is not running
Pressure does not build up in the
appliance
Appliance does not start, motor hums
Strong pressure fluctuations
Appliance is leaking
No detergent infeed